|
| Johnson ( Wall ) |
| Tile-Fixing Instructions |
| |
1. |
Plaster the surface of the wall to tile with a wood finish and complete rendering and curing at least two weeks prior to tiling. DO NOT FIX TILES ON FRESH WALL. |
|
| 2. |
Before fixing the tiles, lay them in desired pattern and make sure that they give an acceptable blend of colour. Also make sure that the tiles are acceptable to your satisfaction. Please note that certain amount of shade & size variation is inherent in all ceramic products. THE COMPANY WILL BEAR NO LIABILITY AFTER THE TILES ARE FIXED. |
| 3. |
The Company bears no responsibility towards the tiles that are exposed to any outside processes like transfers, printing, firing etc. |
| 4. |
For fixing wall tiles we recommend the use of BAL-ENDURA tile fixing adhesives. For best results, follow the tile fixing instructions provided along with the adhesive. |
| 5. |
For fixing wall tiles using sand cement, follow the instruction given below:- |
| |
|
| a. |
Use cement and sand mortar in the ratio of 1 : 3. Add some water to create a consistent paste. DO NOT USE NEAT CEMENT FOR FIXING TILES. |
| b. |
Once the mixing has been complete, do not add any further water and use the same within one hour. |
| c. |
Soak the tiles in clean water for at least 30 minutes before fixing. |
| d. |
Remove the tiles from the water and allow them to drain to ensure that there is no film of water on the surface. |
| e. |
Apply the bedding material evenly and tap it firmly back into position to ensure proper contact between the tile and wall. |
|
|
| |
6. |
The Work size which we try to maintain for better technical performance is + 2 mm on an average. It is advisable to maintain a gap of 1-2 mm between every two tiles to allow for possible expansion as per BIS/EN tolerance norms. |
|
| |
7. |
Wait for 24 hours after fixing the tiles. After this period fill the joints with BAL-GROUT. |
|
| |
8. |
15 minutes after the grouting process, wipe off the excess grout with a damp sponge and polish with a soft, dry cloth. |
|
| |
9. |
Please note that the company does not accept any liability incase of problems arising out of non-adherence to these tiles fixing instructions. |
|
| |
10. |
Please note that wall tiles are especially manufactured for use on the wall only. DO NOT FIX WALLTILES ON THE FLOOR. |
|
| |
11. |
For cleaning tiles, use water or diluted soap solution followed by water with soft moist cloth or sponge. DO NOT SCRUB OR SCRATCH (especially for luster finish wall tiles and border tiles). |
|
| |
12. |
DO NOT USE ACID/ALKALI/SOLVENT/CLEANING POWDERS ETC. FOR CLEANING TILES. (Especially for luster finish wall and border tiles.) |
|
| |
|
NOTHING IN THESE INSTRUCTIONS IS A SUBSTITUTE
FOR GOOD WORKMANSHIP AND SUPERVISION |
|
| |
|
Top |
|
